VAG-COM USB 409.1 cable manufacturer from China Shenzhen Master Automobile Tech. Co.,Ltd

Place of Origin:

Guangdong, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

This VAG_COM OBD II interface enables you to connect your PC to your car so that you can troubleshoot any problems in your vehicle by reading the Dia

This VAG_COM OBD II interface enables you to connect your PC to your car so that you can troubleshoot any problems in your vehicle by reading the Diagnostic Trouble Codes (DTC's) that appear when the 'check engine' light is showing.

Workable Models

This diagnostic cable is usable for ISO9141 and KWP2000 transmission protocol (16pin OBD II style Data Link Connector).

Reference Data

This cable can not work if your car uses a protocol/bussystem like VPW, PWM or CAN-bus.
Terminal K = Bus of communication
Terminal L = Ignition for waking up car computing system (ECU: Engine Control Unit)
Existed 3 different protocols with same OBD2 connector incl. ISO/KWP, VPW, PMW
This K/L Diagnostic interface & cables work on ISO/KWP (Key Word Protocol) launched after 1996 only.
Supported also ISO9141 protocol
The Cables may work with some versions of the Carsoft, but carsoft used a lot of different interfaces during the different versions and also had some custom interfaces.

Features

Supports VAG-COM version 409.1 or older
Fully automatic support for 2002+ Audi models with dual K-lines
High quality precision moulded diagnostic connector made to fit all Audi/VW vehicles
LED light shows cable communication status
Fully CE approved
In-built electronic protection from 'aftermarket radio problems'
This purchase is for one 145cm long, 16 pin OBD diagnostic socket to RS232 9 pin interface cable with USB connector

About VAG-COM

VAG-COM is a Windows based diagnostic software for Volkswagen, Audi, Seat and Skoda vehicles that emulates the functions of expensive professional scan tools. It is:

Fully compatible with all models of the above makes of car or van produced between 1996 and 2006 (see below for more information on earlier models)
Compatible with the above makes of car with CAN connection
Has a data base of more than 7500 fault codes and measuring block texts
Can use the new 7 digit PIN/SKC codes to match new keys in all immobilizer-equipped W, Audi, Seat and Skoda models

Is my Car VAG-COM Compatible?

VAG-COM will work with most Volkswagen and Audi models sold worldwide from 1994 onwards. It will also work with most late-model SEAT and Skodas sold outside of N. America.See below for full list. It does not work with diesel engines.

If your VW or Audi has a 16pin OBD II style Data Link Connector then VAG-COM will work. If your car has the old 2x2 Data Link Connection check to see if there is a wire going to each pin - if there are 4 wires VAG-COM should work – if there are only 3 it won’t.